ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 176)

13-18 Filter Configuration
13.5.2 Remote Node Filters
Go to menu 11.5 (shown next – note that call filter sets are only present for PPPoE encapsulation) and enter
the number(s) of the filter set(s) as appropriate. You can cascade up to four filter sets by entering their
numbers separated by commas. Enter 1 in protocol filters under Output Filter Sets when using Ethernet
encapsulation, and in the protocol filters field under Call Filter Sets when using PPPoE or PPTP
encapsulation. Apply them as shown in the following figure.
Figure 13-15 Filtering Remote Node Traffic
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Apply
factory
default
Filters
here.