ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 - Manual (Page 165)

Prestige 324 Intelligent Broadband Sharing Gateway
Filter Configuration 13-7
separate menu fields are provided for protocol and device filter sets. If you include a protocol filter set in a
device filter field or vice versa, the Prestige will warn you and will not allow you to save.
13.2.3 TCP/IP Filter Rule
This section shows you how to configure a TCP/IP filter rule. TCP/IP rules allow you to base the rule on
the fields in the IP and the upper layer protocol, e.g., UDP and TCP headers.
To configure TCP/IP rules, select press [ENTER] to open Menu 21.1.1 - TCP/IP Filter Rule, as shown
next.
Figure 13-6 Menu 21.1.1 — TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Table 13-3 TCP/IP Filter Rule Menu Fields
FIELD DESCRIPTION EXAMPLE
Active Yes activates and No deactivates the filter rule. Yes
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 0 IP Source Route= No
Destination: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
TCP Estab= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.