Xerox 83xx - Manual (Page 25)

3-11
Step 4 :
Check if the edges of the loop are aligned on each other.
Step 5 :
Raise the pressure rollers. Slide the end of the strip (1) under the pressure rollers (4) and move
it to position 1 as shown on the picture below. Lower the pressure rollers.
No Description
1 Synthetic paper strip
2 Paper loop
3 Tensioning bars
4 Pressure rollers
Step 6 :
Go to the FRONT SIDE of the printer.
Step 7 :
Carefully pull the strip to create some tension.
Caution
•
Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
•
Make sure that you have an equal tension on the left and right of the strip.