Xerox 83xx - Manual (Page 27)

3-13
Step 4 : Carefully pull the strip to create some tension.
Caution
•
Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
•
Make sure that you have an equal tension on the left and right of the strip.
Step 5 :
Place the adjustment plate onto the strip and slide it against the pressure rollers. See image
below.
Step 6 :
Draw a line for the second time. The following two situations can be obtained.
Line overlap each other
► well adjusted
Line does NOT overlap each other
► perform the adjustment procedure as described in the next chapter