Xerox 83xx - Manual (Page 31)

3-17
Step 5 : Slide the end of the synthetic paper strip (1) under the pressure rollers (4) in position 1 of the
printer until the synthetic paper strip (1) is a little tensioned.
No Description
1 Synthetic paper strip
2 Loop
3 Core
4
Pressure rollers
Caution
• Don’t pull too hard on the strip. This will loosen the tape, resulting in the fact that the loop
becomes longer, leading to a bad calibration check.
• Make sure that you have an equal tension on the left and right of the strip.