Yamaha CLP-230 - Manual (Page 65)

CLP-240/230: Keyboard Stand Assembly
CLP-240/230 Owner’s Manual
ENGLISH
65
CLP-240/230: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble the unit
in the appropriate sequence.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size. Using of incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
1.
Attach D and E to C.
1-1
Untie and straighten out the bundled cord. Don’t
discard the twist tie, you’ll need it later in step 5.
1-2
Secure C using the four 6 x 25 mm long screws.
Have a Phillips-head (+) screwdriver ready.
A
B
C
D E
Styrofoam pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads to protect the connector panel at
the bottom of A.
Bundled pedal cord inside
6 x 25 mm long screws x 4
6 x 16 mm short screws x 4
4 x 12 mm thin screws x 2
4 x 20 mm tapping screws x 4
4 x 10 mm thin screws x2
Cord holders x 2
AC power cord
Headphone hanger
Side panel protection
(cardboard) pads x 2
(The shape of plug differs
depending on locale)
1-2
1-1