Zoom HD16 - Manual (Page 137)

Reference [Effects]
ZOOM HD8/HD16 137
5.
Turn the dial to select the import source
project, and press the [ENTER] key.
The subsequent steps differ, depending on which selection was
made in step 3.
● When “ALL” was selected
Verify that the indication “Import?” is shown on the display
and proceed to step 6.
● When “PATCH” was selected
The import source patch appears on the display. When you
turn the dial to select the patch and press the [ENTER] key,
the import target patch selected in step 1 is shown. If
necessary, turn the dial to select the number of the patch to
use as import target, and press the [ENTER] key. The
indication “Import?” appears on the display.
6.
To carry out the import process, press the
[ENTER] key.
All patches or the specified patch of the selected project will be
imported. When all patches were imported, the insert effect or
send/return effect select screen appears again. When a single
patch was imported, the display of step 4 appears again.
By pressing the [EXIT] key instead of the [ENTER] key, you
can cancel the operation and back up one step at a time.
Import Import
No.1:PRJ001
No.1:PRJ001
Project name Project number