Permission permission all fader on all fader on, Deleting certain parameters from a scene – Zoom HD16 User Manual

Page 85

Advertising
background image

Reference [Mixer]

ZOOM HD8/HD16

85

song as well as all other mix settings as

scenes.

4.

While the recorder is stopped, press the

ZERO [

U

] key in the transport section to

move to the recorder start position.

The beginning of the song (counter zero location) already
contains the mark number 00. Assign the starting scene to this
mark.

5.

Press the [MARK] key.

When you press the [MARK] key at a location where a mark
has been assigned, a screen will appear in which you can
assign a scene to the corresponding mark.

NOTE

If you press the [MARK] key at a location where no mark has

been assigned (marker symbol shown in reverse), a new mark

will be assigned to that location. Take care not to assign a mark

by mistake. If required, user the MARKER [

U] / [I] keys to

match the current position with the marker point.

6.

Turn the dial to select the number of the

scene you want to assign to this mark, and

press the [ENTER] key.

The scene will be assigned to the mark.

HINT

To cancel a scene assignment, turn the dial until the display

indicates “ -- “.

7.

Use the MARKER [

T

]/[

Y

] keys to locate the

next mark at which you want the mix to

change, and assign a scene in the same way.

8.

When all desired scenes have been assigned,

move to the start position of the recorder, and

start playback.

Each time the song reaches a mark to which a scene has been
assigned, the settings of that scene will be recalled.

9.

Press the [EXIT] key to return to the main

screen.

If desired, you can disable a group of parameters saved in a
scene. Such parameters will not change even if the scene is
changed. The following groups of parameters can be specified
and made active or inactive.

For example, after you have programmed a sequence of
automatic scene changes, you may want to disable only the
TRACK PARAMETER group and set the EQ and panning
parameters manually for each track.

1.

Press the [SCENE] key in the control section,

and then press the [PROJECT/UTILITY] key

in the display section.

The display changes as follows. In this condition, you can
select whether the scene controls the fader action.

2.

Turn the dial to set fader permission to On or

Off.

3.

To exclude other groups except for the fader

from scene control, press the key or pad for

the respective group.

Except for the fader, scene control for the other groups can be
enabled or disabled by pressing one of the keys or pads listed
below, in the condition of step 1.

• TRACK PARAMETER group

Status key for the track to enable/disable, except
[MASTER] status key

• INSERT EFFECT group

Pad 4 (INSERT EFFECT)

Mark Edit

Mark Edit Ó00

00

--

--

Mark Edit

Mark Edit Ó00

00

No.0:Scene0

No.0:Scene0

Deleting certain parameters
from a scene

Group

Item

TRACK PARAMETER

EQ HI

EQ MID

EQ LO

CHORUS/DELAY SEND

REVERB SEND

PAN

Play/Mute

INSERT EFFECT

Patch number

Input source

CHORUS/DELAY

Patch number

REVERB

Patch number

ALL FADER

Fader position

MASTER FADER

[MASTER] fader position

Permission

Permission
All Fader On

All Fader On

Advertising
This manual is related to the following products: