Checking the system version, Hard disk maintenance – Zoom HD16 User Manual

Page 171

Advertising
background image

Reference [Other Functions]

ZOOM HD8/HD16

171

4.

Turn the dial to change the setting to a value

from 1 – 3.

5.

When the setting is complete, press the

[EXIT] key several times to return to the main

screen.

To check the system software version of the HD8/HD16,
proceed as follows.

1.

From the main screen, press the [PROJECT/

UTILITY] key.

The indication “REC UTILITY” appears on the first line of the
display, and “PROJECT” is shown on the second line.

2.

Use the cursor left/right keys to bring up the

indication “SYSTEM” on the second line of

the display, and press the [ENTER] key.

The display indication changes as follows.

3.

Use the cursor left/right keys to bring up the

indication “SYSTEM VERSION” on the

second line of the display, and press the

[ENTER] key.

The current system version is shown.

To return to the main screen, press the [EXIT] key several
times.

This section describes how to test and restore the integrity of
data on the internal hard disk of the HD8/HD16, and how to
perform other hard disk maintenance functions.

The procedure for hard disk maintenance is the same for most
operations. The basic steps are described below.

1.

Turn power to the HD8/HD16 off. While

holding down the [CLEAR] key in the control

section, turn power on again.

The HD8/HD16 starts up in “HDD utility mode” which serves
for performing special functions.

2.

Use the cursor left/right keys to select the

desired command.

The following commands are available.

INIT ALL (All Initialize)

Format the hard disk and restore system files and various
data necessary for operation. All existing projects will be
erased.

INIT FACTORY (Factory Initialize)

Restore system files and various data necessary for
operation. Data created by the user will not be erased.

SCAN DISK

Test and repair the integrity of data stored on the internal hard
disk.

3.

Press the [ENTER] key to execute the

command.

Subsequent display indications and operation steps differ for
the individual commands. See the respective section below.

4.

When the command has been executed, turn

the unit off and then turn it on again.

The HD8/HD16 will operate in normal mode.

Checking the system
version

SYSTEM 1/7

SYSTEM 1/7
>FOOT SWITCH

>FOOT SWITCH

ZOOM HD16

ZOOM HD16
Ver:1.00

Ver:1.00

Hard disk maintenance

Basic maintenance procedure

HDD UTILITY 1/3

HDD UTILITY 1/3
>INIT ALL

>INIT ALL

Advertising
This manual is related to the following products: