Copying a specified range of data – Zoom HD16 User Manual

Page 51

Advertising
background image

Reference [Track Editing]

ZOOM HD8/HD16

51

editing target will also be a single track.

• When two tracks or the master track have been selected as

editing source, the editing target will also be two tracks or the

master track. The currently selected V-take for each track will be

the target.

6.

Press the [ENTER] key.

The subsequent steps will differ, depending on which
command was selected in step 4. See the following sections for
the respective commands.

7.

When the editing command has been

executed, repeatedly press the [EXIT] key to

return to the main screen.

NOTE

After executing an edit command for rewriting the audio data

on a track, the original data cannot be restored. To retain the

condition before editing, use the capture and swap functions

(

p. 65) for that track.

You can copy the audio data of a specified range to a specified
position on a specified track/V-take. This action will overwrite
the existing data at the destination location. The copy source
data will be unchanged.

1.

Refer to steps 1 – 6 of “Basic steps for range

editing” and select the COPY command.

Select the copy source track/V-take, and

press the [ENTER] key.

The display for specifying the copy start point appears.
The range start point can be specified minutes/seconds/
milliseconds, or in measures/beats/ticks.
You can also specify the point using markers (

p. 47). Use the

cursor up/down keys to switch units.

2.

Use the cursor left/right keys to move the

flashing section of the counter, and turn the

dial to specify the copy start point.

When a value is specified, the other units currently not shown
on the display also reflect the new location.

NOTE

If you specify a point where no audio data exist, the display

shows a “

✽ ” symbol.

3.

Press the [ENTER] key.

The second line of the display now lets you specify the copy
range end point.

4.

Use the same procedure as in step 2 to

specify the copy range end point.

If you press the PLAY [

R] key at this point, the specified

range will be played.

5.

Press the [ENTER] key.

The first line of the display now shows “Copy Destination” and
the second line “Trackxx-yy” (where xx is the track number
and yy the V-take number). This display lets you specify the
copy destination.

HINT

You can select the same track as copy source and copy

destination. In this case, the copy source range and copy

destination range may overlap, but copying is still possible.

6.

Specify the copy destination track/V-take in

the same way as when selecting the copy

source, and press the [ENTER] key.

The display shows the copy destination start point.

Copying a specified range of
data

Copy source track

Copy target track

Copy

Start 000:00:000

Start 000:00:000

Start 001-01-00

Start 001-01-00

Start

Start Ó00

00

Minutes/seconds/milliseconds

Measures/beats/ticks

Marker position

Start 000:00:000

Start 000:00:000
End 003:15:000

End 003:15:000

Copy Destination

Copy Destination
To 003:15:000

To 003:15:000

Advertising
This manual is related to the following products: