Zenoah CHTZ2401 - Manual (Page 12)

12
sufficient to ensure safety.
2. Check the condition of working area to avoid any
accident by hitting hidden obstacles such as stumps,
stones, cans, or broken glass.
Remove any obstacle before beginning work.
3. Inspect the entire unit for loose fasteners and fuel
leakage. Make sure that the cutting attachment is
properly installed and securely fastened.
■ STARTING THE ENGINE
1. Keep bystanders especially children, and animals at
least 15 m (50 ft) away from the operating point. If
you are approached, immediately stop the engine.
2. The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment might begin to
rotate as soon as the engine is started. When
starting the engine, place the product onto the
ground in a flat clear area and hold it firmly in place
so as to ensure that neither the cutting part nor the
throttle come into contact with any obstacle when
the engine starts.
Never place the throttle into the high-speed
position when starting the engine.
3. After starting the engine, check to make sure that
the cutting attachment stops rotating when the
throttle is moved fully back to its original position. If it
continues to rotate even after the throttle has been
moved fully back, turn off the engine and take the
unit to your authorized KOMATSU ZENOAH
servicing dealer for repair.
■ USING THE PRODUCT
Cut only materials recommended by the
manufacturer. And use only for tasks explained in
IMPORTANT
WARNING
IMPORTANT
5. For safe operation
English