Xantrex Technology GT 2.5-DE - Manual (Page 36)

Installation
2–16 975-0253-01-01
Mounting the Inverter on the Bracket
Before mounting the inverter, it is recommended to remove the communication
ports cover. With the cover removed, you can access all the mounting slots along
the bottom flange.
Mounting a Single Inverter
To mount the inverter on the mounting bracket:
1. Place the GT Inverter’s mounting hook, located on the back of the enclosure,
over the bracket and ensure the inverter is seated properly, as shown in
Figure 2-8.
2. After the unit is correctly seated on the bracket hook, locate the mounting
slots at the bottom of the unit, and mark the location on the wall for securing
screws.
3. Remove the inverter and drill pilot holes in the wallboard or siding for the
securing screws.
4. Reinstall the GT Inverter on the bracket and secure the bottom of the unit with
appropriate screws or anchors, and tighten.
Figure 2-8 Proper Placement of the Inverter on the Mounting Bracket
Slide the mounting hooks on the inverter
over the hooks on the mounting bracket. Ensure the inverter is
seated properly on the
mounting bracket
flange with
mounting slots 130 cm (51") 100 cm (39")