Zanussi ZWF 1850 W - Manual (Page 17)

17
Interrupting a programme/
Adding washing
Interrupting a programme
• The programme can be interrupted at any time by
pressing the START/PAUSE key. It is then re-start-
ed by pressing the key again.
• To stop the washing machine before the pro-
gramme has ended, turn the programme knob
to OFF.
Important! Be careful if there is water in the appli-
ance!
Adding washing
1. Press the START/PAUSE key.
• If “Door locked” and “Pause” are alternately shown
in the display, it is no longer possible to add wash-
ing, e. g. when the water level is too high.
• If “Door openable” and “Pause” are alternately
shown in the display, it is still possible to add
washing:
2. Open the door.
3. Add washing and close the door again.
4. Press the START/PAUSE key again. Programme
will continue.
End of the wash cycle/
Removing the washing
At the end of the programme, “Cycle ended” and
“Door openable”are alternately shown in the display.
1. Open the door and remove the washing.
2. Turn the programme knob to OFF.
3. Turn off the tap.
4. When you have finished washing, pull out the de-
tergent drawer a little to let it to dry out. Keep the
door very slightly open so that the washing ma-
chine can air.
If RINSE HOLD or NIGHT CYCLE
was selected:
After a RINSE HOLD or when a programme with
NIGHT CYCLE has ended, the START/PAUSE indica-
tor flashes. “Cycle ended” and “Door locked” appear
alternately in the display.
The water must first be drained off:
– Turn the programme knob to OFF, then to DRAIN
and press the START/PAUSE key (the water is
drained without spinning),
or
– turn the programme knob to OFF and then to
SPIN. Change the spin speed if necessary and
press the START/PAUSE key (the water is drained
and the washing spun).