Zanussi ZWF 1850 W - Manual (Page 24)

24
If the wash result is not sat-
isfactory
The washing is grey and there are limes-
cale deposits in the drum
• Too little detergent was used.
• An incorrect detergent was used.
• Individual stains were not pre-treated.
• The programme or temperature was not set prop-
erly.
There are grey stains on the washing
• Items that were soiled with ointments, fats or oils
were washed using too little detergent.
• The wash temperature used was too low.
• A common cause is that conditioner – in particular
the type in concentrated form - has come in con-
tact with the washing. Wash out such marks as
soon as possible and exercise care when using the
said conditioner.
Foam can still be seen following the final
rinse
• Modern detergents can cause foam to be created
even during the final rinse. In spite of this, the
washing has been sufficiently rinsed.
There are white residues on the washing
• What can be seen here are insoluble substances
which modern detergents contain. They are not the
result of insufficient rinsing.
Shake or brush the washing. If possible turn the
washing inside out before washing. Check your
choice of detergent. Especially with dark colours it
is advisable to use liquid detergents.
Display shows: “Excess Detergent”
Probably too much detergent
has been used.
Follow the manufacturer's instruc-
tions exactly when measuring out de-
tergent.
Display shows:
– “No drain - check drain hose/fil-
ter” or
– “Pump Blocked”.
Kink in drain hose. Straighten the hose.
Maximum pumping height of 1m
exceeded. Refer to installation instructions and
make any necessary adjustments.
Drain pump is blocked.
Switch off the appliance. Disconnect
the power plug.
Clean the drain pump. Remove foreign
bodies from the pump housing.
For sink spigot connections:
Sink outlet is blocked.
Clean the sink spigot.
Fabric softener not rinsed in,
compartment for additives is filled
with water.
Conditioner insert in the com-
partment for additives is not
correctly attached or is blocked.
Clean the detergent drawer, insert the
conditioner insert firmly.
The door cannot be opened when
the washing machine is switched
on.
Door locked.
Wait until the display alternately shows
“Door openable” and “Cycle ended”.
There has been a power cut. (All
indicators are off.)
For safety reasons, the door will
remain locked for between 4
and 10 minutes.
The programme will continue when the
power cut is over.
To remove washing:
If water can be seen in the appliance,be-
fore opening the door, first perform an
emergency drain.
Washing is heavily creased.
Possibly too much washing was
loaded.
Observe maximum loads.
Problem Possible cause Remedy