Operation, The ceramic hob, Using the hob – Zanussi ZKT6050 User Manual
Page 12: Automatic warm up, Using the stop + go function, Using the hob timer, Warning
 
 
 
 
 
 
12
Operation
The ceramic hob
WARNING!
Do not use the appliance if the ceramic glass 
is damaged. If a fault or crack becomes 
visible, disconnect the appliance 
immediately from the electricity supply and 
contact your local service force centre. 
Using the hob 
•
The hob must be switched on before 
setting any cooking function or programme. 
•
For single hotplates press the increase
or decrease
control to vary the heat
setting. The highest number represents 
the hottest setting and the lowest number 
represents the coolest setting. Choose a 
setting appropriate to the quantity and type 
of food to be cooked. 
•
To turn off a hob element press increase 
and decrease controls together.
Automatic warm up
All cooking zones are equipped with an 
automatic warm up function. The cooking zone 
switches to full power for a certain amount of 
time and then automatically switches back to 
the heat setting set. 
Press the increase
control and scroll
through the heat settings to 9 then press the 
increase 
control again 'A' will show in the
display. An audible signal will sound. Now 
press the decrease 
control to the setting you
require. The hob will show 'A' in the display 
until the Automatic warm up programme has 
finished then returns to the setting set. 
Using the stop + go function
The stop + go function switches all cooking 
zones that are switched on to the keep warm 
setting and then back to the heat setting that 
was previously set. 
This function can be used to briefly interrupt
and then continue the cooking process.
To switch on press the stop and go control.
The hob display will show the keep warm 
symbol 
.
To switch off press the stop and go control.
The display will revert to the heat setting that 
was previously set. 
Using the hob timer
All cooking zones can use each one of the two 
timer functions at the same time. 
If a cooking zone is switched off, the timer
function set is also switched off.
Function
Condition
Outcome
Automatic cut-
out
A heat
setting is set
Acoustic
signal
00 flashes
Cooking
zone
switches off
Countdown
timer
Cooking
zones not in
use
Acoustic
signal 00
flashes