Residual heat hob, Top oven intelligent grill, Using intelligent grill – Zanussi ZKT6050 User Manual
Page 14: Important, Warning
 
 
 
 
 
 
14
IMPORTANT!
Occasionally the heated areas may be seen to 
switch on and off when higher heat settings are 
being used. This is due to a safety device, 
which prevents the glass from overheating. 
 
Some switching on and off when cooking at high 
temperatures, e.g. deep fat frying is quite 
normal, causes no damage to the hob and little 
delay in cooking times. 
Excessive switching may however be
caused by the use of an unsuitable saucepan or 
a saucepan which is smaller than the heated 
area. If excessive switching occurs, discontinue 
use of the saucepan. 
Residual heat HOB
When a hob function has been switched off the 
residual heat indicator will remain alight to indicate 
that the hob is still hot. ‘ H‘ will show in the 
display until the appliance has cooled. If the 
appliance is switched off at the supply before the 
hob has fully cooled, the residual heat indicator will 
remain illuminated when the electricity is restored. 
This is a safety precaution.
To fit the top oven shelf
The shelf should be fitted with the straight rods 
uppermost on the frame and the forms towards the 
back of the oven. 
 
 
 
To remove a shelf slide the shelf towards you until 
the shelf stop is reached. Tilt shelf up at the front 
to that the stops clear the side supports. Lift shelf 
clear. To install a shelf, reverse the above steps. 
Each shelf position has an upper and lower 
support. 
WARNING!
Do not place cookware and cooking pots 
with rough bases e.g. cast iron on the oven 
door as damage to the glass may occur. 
Top oven intelligent grill
WARNING!
CAUTION: Accessible parts may be hot 
when the grill is in use. Young children 
should be kept away. 
 
Using intelligent grill 
•
The oven must be switched on before 
setting any cooking function or programme. 
•
Press the Oven Cavity selector until the 
top oven cavity indicator is illuminated. 
•
Press the Function selector
until the
required setting is shown
.
•
To use the grill at lower settings press the 
function selector 
untill the required
setting is shown
.
•
Wait 5 seconds until your choice is 
confirmed. The temperature will 
automatically set to 250°C if grilling with 
the door closed.