Zoom B22 - Manual (Page 26)

Effect Types and Parameters
ZOOM B2 26
MS MONO SYN (Mono Synth)
This is a monophonic (single-note) bass synthesizer that detects the input signal pitch.
CABINET oF, 1 – 3 VARI
s1 – s5, p1 –
p5, m1 – m5
DECAY 0 – 98, 1.0
Numeric settings select different cabinet
types.
Selects the waveform type and sound
variation. "s" produces a sawtooth wave,
"p" produces a square wave, and "m"
uses PWM (pulse width modulation).
Adjusts the rate of sound change.
ZNR/MIX
ZNR/MIX module
This module serves for reducing noise during playing pauses. The module also is used to
control the mixing balance of original sound and effect sound for the DRIVE/SYNTH
module, and the signal level after the module. The ZNR/MIX module cannot be turned off
with the foot switch. To disable ZNR, set the effect parameter value to "oF".
nr ZNR (ZOOM Noise Reduction)
This is ZOOM's original noise reduction that suppresses noise in playing pauses without affecting the tonal
quality of the sound. Also allows adjusting the mixing balance and level of the DRIVE/SYNTH module.
ZNR oF, Z0 – Z9 MIX BALANCE 0 – 98, 1.0 LEVEL 2 – 98, 1.0
Adjusts the ZNR sensitivity. For
maximum noise reduction, set the value
as high as possible without causing the
sound to cut in or decay unnaturally.
Adjusts the mixing balance
between the signal before input to
the DRIVE/SYNTH module and
the signal after passing the
module. Higher setting values
result in stronger WET sound.
When the DRIVE/SYNTH
module is set to Off, the
indication "oF" is shown.
Adjusts the signal level after passing the
DRIVE/SYNTH module. When the
DRIVE/SYNTH module is set to Off,
the indication "oF" is shown.
LO EQ
LO EQ module
This is an equalizer for the low frequency range. You can select either a 3-band equalizer
or parametric equalizer.
LE LO EQ (Low EQ)
This is a 3-band equalizer that adjusts the frequency range below 450 Hz.
70Hz ±12 150Hz ±12 450Hz ±12
70 Hz, shelving type equalizer. 150 Hz, peaking type equalizer. 450 Hz, peaking type equalizer.
LP LO PARAMETRIC EQ (Low Parametric EQ)
This is a parametric equalizer that adjusts the frequency range below 650 Hz.
TYPE 1, 2, SH FREQUENCY See Table 1 GAIN ±12
Selects the type of filter. "1" gives a
peaking type filter with narrow Q, "2"
gives a peaking type filter with wide Q,
and "SH" produces a shelving type LO
EQ.
Selects a frequency within the range of
100 - 650 Hz.
Adjusts the gain.
Table 1
Display Frequency Display Frequency
10 100Hz 50 500Hz
25 250Hz 65 650Hz
35 350Hz
MS
NR
LE
LP
EB2.fm 26 ページ ２００５年７月２７日 水曜日 午後４時１５分