X10 Wireless Technology VK84A - Manual (Page 3)

4 5
Connect the camera to power.
Plug the camera’s power supply into a standard wall outlet. Plug the
other end into the camera. Remove the protective cover from the
camera’s lens.
Basic Camera Setup
Your SentinelPro Camera is ready to go out of the box! Follow these
steps for a quick setup of your new camera.
You should have: the camera and its power supply; the camera
remote; the camera mounting bracket, a weather resistant dome, and
the screws to install the bracket. A wireless video receiver, and it’s
video cable and power supply (shown above but sold separately) is
also required if you want to use the camera wirelessly.
Unpack these items.
B
ASIC
C
AMERA
S
ETUP
First you’ll set up and test the camera before you install the camera
into the dome. Make sure you read this entire manual fi rst in case you
want to change a setting on the base of the camera before installing it
in the dome.