X10 Wireless Technology VK84A - Manual (Page 9)

16 17
Clearing Stored Positions
You can delete all stored positions. Here’s how:
1. Press and release C1.
2. Press and hold Setup until the C1 button lights green.
3. Press Center.
4. Press Setup again.
Focus Controls
In addition to the auto focus feature, you can control the focus of the
camera manually. Press the focus buttons, Up or Down, to adjust the focus.
Use this feature to improve the picture after auto focus, or to adjust the
focus of a specifi c object in the camera’s view.
Iris Controls
The camera’s iris controls the amount of light that enters the lens. The
camera automatically adjusts the iris when it focuses so that it has the right
amount of light for your subject. If you want to brighten the picture, press
the Iris Up button to open the iris wider and let more light in. To limit the
amount of light in the picture, press Iris Down to close the iris more.
Remote Control Features Mounting the Camera
Brass screw
Warning! The power supply is intended for indoor use only. Do not install
the power supply outdoors.
You can install the SentinelPro Camera into the supplied dome and mount
it on a ceiling, or you can use the supplied mounting bracket to mount the
complete assembly on a wall. In either case make sure the ABCD channel
switch, and Transmit Enable/Disable switch on the base of the camera are
set as you desire before installing the camera in the dome.
You can then attach the camera to the base of the dome using the brass
screw on the outside of the dome’s base.