X10 Wireless Technology VK84A - Manual (Page 6)

10 11
Once the camera and receiver are in place, adjust their antennas so
that they face each other. The side of the camera’s antenna with the
dot on it should face the side of the receiver’s antenna marked with
four squares. Adjust the positions to improve the picture on your TV.
Basic Camera Setup
Fine tune the antennas. Turn on your TV.
Turn on your TV and select its video input. Use the Video or Select
buttons on your TV remote control, or try channel 0 and then
Channel Down. The camera’s picture should appear. Note, the picture
will be upside down because the camera is intended to be mounted
on a ceiling or overhang, after installing it into the dome. See page
22 if you want to fl ip the picture.
Basic Camera Setup