ZyXEL Communications GS-2750 - Manual (Page 210)

Chapter 24 IP Source Guard
GS-2750 User’s Guide
210
Figure 104 ARP Inspection Log Status
The following table describes the labels in this screen.
Table 77 ARP Inspection Log Status
LABEL DESCRIPTION
Clearing log status table Click Apply to remove all the log messages that were generated by ARP
packets and that have not been sent to the syslog server yet.
Total number of logs This field displays the number of log messages that were generated by
ARP packets and that have not been sent to the syslog server yet. If one or
more log messages are dropped due to unavailable buffer, there is an
entry called overflow with the current number of dropped log messages.
Index This field displays a sequential number for each log message.
Port This field displays the source port of the ARP packet.
VID This field displays the source VLAN ID of the ARP packet.
Sender Mac This field displays the source MAC address of the ARP packet.
Sender IP This field displays the source IP address of the ARP packet.
Num Pkts This field displays the number of ARP packets that were consolidated into
this log message. The Switch consolidates identical log messages
generated by ARP packets in the log consolidation interval into one log
message. You can configure this interval in the ARP Inspection
Configure screen. See Section 24.7 on page 211 .
Reason This field displays the reason the log message was generated.
dhcp deny: An ARP packet was discarded because it violated a dynamic
binding with the same MAC address and VLAN ID.
static deny: An ARP packet was discarded because it violated a static
binding with the same MAC address and VLAN ID.
deny: An ARP packet was discarded because there were no bindings with
the same MAC address and VLAN ID.
dhcp permit: An ARP packet was forwarded because it matched a
dynamic binding.
static permit: An ARP packet was forwarded because it matched a static
binding.
In the ARP Inspection VLAN Configure screen, you can configure the
Switch to generate log messages when ARP packets are discarded or
forwarded based on the VLAN ID of the ARP packet. See Section 24.7.2
on page 213 .
Time This field displays when the log message was generated.