ZyXEL Communications GS-2750 - Manual (Page 267)

Chapter 32 Access Control
GS-2750 User’s Guide
267
Figure 153 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 107 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must
match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP
version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP
version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version
2c or lower.
Set Community Enter the Set Community, which is the password for incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version
2c or lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to
the SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP
version 2c or lower.
Trap Destination Use this section to configure where to send SNMP traps from the Switch.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps to.
Port Enter the port number upon which the manager listens for SNMP traps.