ZyXEL Communications GS-2750 - Manual (Page 43)

Chapter 3 Hardware Overview
GS-2750 User’s Guide
43
3.1.3.1 Transceiver Installation
Use the following steps to install a mini GBIC transceiver (SFP or XFP module).
1 Insert the transceiver into the slot with the exposed section of PCB board facing down.
Figure 9 Transceiver Installation Example
2 Press the transceiver firmly until it clicks into place.
3 The Switch automatically detects the installed transceiver. Check the LEDs to verify that
it is functioning properly.
Figure 10 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).
1 Open the transceiver’s latch (latch styles vary).
Figure 11 Opening the Transceiver’s Latch Example
2 Pull the transceiver out of the slot.