Zenith L20V54S - Manual (Page 20)

Auto Program (Channel Search)
P A G E 2 0
With the optional Installer remote control in hand, press
the POWER key to turn the TV on.
Press the MENU button and then use the ADJ D D / E E button
to select the Channel menu.
Press the OK (Enter) button.
With Auto Program highlighted, press the OK (Enter)
button.
Press the OK (Enter) button to start the channel search.
After finding all available channels, a display appears
briefly showing the number of analog and digital channels
found.
Press the MENU button to remove the menus.
1
2
3
4
5
6
Use Auto Program to automatically find and store all of
the channels available in the selected Tuning Band.
*Note: Tuning Band must be set before doing the channel search. See
Installer menu item 003 Band/AFC. Default setting is 1, for CATV. When
Auto Program is run, any assigned channel labels are automatically
removed.
Auto Program finds channels being received by the TV’s
analog and digital tuners.
Cable will not work unless you subscribe to a cable service.
Channel
Move Select OK Menu Back
Antenna
Auto Program G
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--. -- ----
Channel
Searching ...
ANALOG34 added
30
Menu Back
Antenna
Auto Program
Channel Label
Channel List
Fine Tune
Signal Strength
--:-- --
--. -- ----