Zenith L20V54S - Manual (Page 51)

P A G E 5 1
Reference: Procedures for adding Channel Label Icons/Custom Channel Labels
(2-5-4 + MENU Mode)
Adding Channel Icons and Labels in the 2-5-4 + Menu Mode
Installer Remote Control Key Functions for Master TV Channel Editing/Labeling Menu
Editing/Adding Channel ICONs and/or Labels
If there is no pre-assigned ICON, you can make a channel label of up
to 7 characters to help in identifying the channel or network.
At your option, channel labels can also be added in addition to a
pre-assigned ICON. You may also add labels for the Aux input sources
to clearly identify the devices that are connected to the Aux inputs. Editing and adding the labels can only be done if there are
channels entered into the L20V54S’s channel map either by
using the method described in item 6 (page 51), by cloning or
by the use of the master remote control from the PPV provider.
To Do Channel Editing/Labeling, proceed as follows
1. Enter L20V54S Installer menu.
2. After the installer menu appears, press ‘2’, ‘5’, ‘4’, ‘MENU’.
This enters the channel label edit mode.
Add your channel icons and channel labels in this menu,
see below. (You can do this more than once.)
3. To exit the menu when done press “MENU”.
• CHANNEL Up/Down - Tunes in the next channel in scan.
• Left/Right Arrows - Select the item to change. If “I” is shown,
the ICON can be changed. If a number is shown, it indicates the
position of the character that can be changed.
• Up/Down Arrows - Select the ICON or the character to be
displayed.
• 0 – 9 - Use to enter the index number of the ICON, if known.
• OK (Enter/Select) - Changes the ICON after the number has been
entered.
• TV/AV - Changes the Aux input label. This key is located on side
of set and on Installer remote control.
• MENU - Exits the labeling/editing menu.
Changing a Channel’s ICON on Master
TV
1. With Channel Up/Down, select the channel
you want to change the Icon for.
2. With the Right or Left ADJ arrow, select
the letter ‘I’ on the channel ID display.
3. With the Up or Down arrow, select the
desired ICON you want to appear to
identify the channel. (If you know the
ICON number, enter the number followed
by Enter / Select.)
*Note: If no Icon is available, leave at or
select the default blank icon display.
4. Proceed with Changing/Adding Labels or
go to the next channel.
Changing/Adding Channel Labels on
Master TV
1. Channel Up/Down to select the desired
channel.
2. Press the Right or Left ADJ arrow
repeatedly until the numbers 1 to 7 show
up. The number shows the position of the
character that can be changed. Number 1
is the first character, number 2 the second
character and so on.
3. With the Up or Down arrow, select the
desired character.
4. Proceed to the next number position or
use Channel Up/Down to go to the next
channel.
Changing Source Labels on Master TV
1. Press “TV/AV” to select the desired Aux
input source; Video 1, HDMI.
2. Press the Right or Left arrow repeatedly
until the numbers 0 to 9 show up.
The number shows the position of the
character that can be changed.
3. Use the Up or Down arrows to select the
desired character.
4. Press “TV/AV” for the next Aux source or
proceed with Changing Icon or
Changing/Adding Labels.
1 2 3 4 5 6 7
XYZ
XYZ
XYZ
NETWORK
(Label)
(Icon)