Zenith L20V54S - Manual (Page 44)

Cloning Connections / Teaching Setup
P A G E 4 4
Teaching the Master Setup to Another L20V54S
Connections for the LT2002 to Teach another L20V54S the Master Setup
Teach Master L20V54S’s Setup to the target
L20V54S
After learning is complete, remove the M.P.I. cable from the
master L20V54S and connect it to the target L20V54S that you
want to copy the master L20V54S’s setup into. With “THE CLONE
HAS CONTROL OF TV” message displayed, press 2 to go to the
“TEACH TO TV” option, press ON/OFF, POWER, or ENTER.
Select the LT2002 memory that the new setup is in. Press
On/Off to transfer the new setup and other information to the
new L20V54S. Teaching usually takes 2-3 minutes.
After the “TEACHING COMPLETE” message is displayed, press any
key to return to the Clone menu, then press ON/OFF, POWER, or
ENTER. If finished, detach M.P.I. cable from the target, newly
cloned L20V54S.
Disconnect L20V54S Power for 15 Seconds
Unplug the AC power cord of the newly cloned L20V54S from
the power outlet for about 15 seconds to activate the
newly-copied setup.
CLONE SELECTION MENU
(1) LEARN FROM TV
(2) TEACH TO TV
(3) SET CLONE CLOCK FROM TV
(4) SET TV CLOCK FROM CLONE
(5) DISPLAY TV SETUP
(6) DISPLAY CLONE SETUP
- TO CHANGE MENU ITEMS, PRESS
CHANNEL KEYS OR DIGITS.
- TO EXECUTE ITEM, PRESS ON/OFF,
POWER, OR ENTER
TEACHING IN PROGRESS,
PLEASE WAIT
TEACHING COMPLETE
This menu should appear after any key is
pressed on the Installer remote.
This display will appear during Teaching
function.
This display will appear after Teaching is
complete.
Clone Programmer Master L20V54S
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV