ZyXEL Communications P-2302R-P1 - Manual (Page 107)

P2302R-P1 Support Notes
All contents Copyright

2007 ZyXEL Communications Corporation.
107
How do I used the reset button, more over what field of parameter will be reset by reset
button?
You can used a sharp pointed object insert it into the little reset hole beside the power connector. Press down
the reset button and hold down for approx 5 second, the unit will be reset. When the reset button is pressed the
devices all parameter will be reset back to factory default include, password, and IP address.
The default IP address is 192.168.1.1, Password 1234.
What network interface does the new ZyXEL Device support?
The new ZyXEL Device support auto MDX/MDIX 10/100M Ethernet LAN/WAN port to connect to the
computer on LAN and 10/100M Ethernet to connect to the external cable or ADSL modem on WAN.
How does the ZyXEL Device support TFTP?
In addition to the direct console port connection, the ZyXEL Device supports the uploading/download of the
firmware and configuration file using TFTP (Trivial File Transfer Protocol) over LAN.
Can the ZyXEL Device support TFTP over WAN?
Although TFTP should work over WAN as well, it is not recommended because of the potential data corruption
problems.
How can I upload data to outside Internet over the one-way cable?
A workaround is to use an alternate path for your upstream path, such as a dialup connection to an Internet
service provider. So, if you can find another way to get your upstream packets to the Internet you will still be
able to receive downstream packets via the ZyXEL Device.
How fast can the data go?
The speed of the cable modem is only one part of the equation. There are a combination of factors starting with
how fast your PC can handle IP traffic, then how fast your PC to cable modem interface is, then how fast the
cable modem system runs and how much congestion there is on the cable network, then how big a pipe there is
at the head end to the rest of the Internet.
Different models of PCs and Macs are able to handle IP traffic at varying speeds. Very few can handle it at 30
Mbps.