ZyXEL Communications P-2302R-P1 - Manual (Page 79)

P2302R-P1 Support Notes
All contents Copyright

2007 ZyXEL Communications Corporation.
79
Label Description
Phone Port
Settings
Use this field to select the phone port that you want to configure.
Speaking
Volume
Use this field to set the loudness that the ZyXEL Device uses for the speech
signal that it sends to the peer device. -1 is the quietest and 1 is the loudest.
Listening
Volume
Use this field to set the loudness that the ZyXEL Device uses for the speech
signal that it receives from the peer device and sends to your phone. -1 is the
quietest and 1 is the loudest.
G.168 Active Select this check box to cancel the echo caused by the sound of your voice
reverberating in the telephone receiver while you talk.
Dialing
Interval
Select
Enter the number of seconds the ZyXEL Device should wait after you stop
dialing numbers before it makes the phone call. The value depends on how
quickly you dial phone numbers. If you select Active Immediate Dial in VoIP
> Phone > Common, you can press the pound key (#) to tell the ZyXEL
Device to make the phone call immediately, regardless of this setting.
VAD
Support
Select this check box to use Voice Activity Detection (VAD) to reduce the
bandwidth that a call uses. The ZyXEL Device will generate and send comfort
noise when you are not talking.
Dialing
Interval
When you are dialing a telephone number the ZyXEL Device waits this long
after you stop pressing the buttons before initiating the call. Select how many
seconds you want the ZyXEL Device to wait after the last input on the
telephone’s keypad before dialing (making) a call.
Apply Click Apply to save your changes back to the ZyXEL Device.
<Back
Cancel
Click this to return to the Analog Phone screen without saving your changes.
Click this to set every field in this screen to its last-saved value.
Common Phone
You can use the pound key (#) to tell the ZyXEL Device to make the phone call immediately, instead of waiting
the number of seconds you selected in the dialing interval.
Go to VoIP> Phone > Common. Where you can activate it.