Zebra Technologies XiIIIPlus - Manual (Page 13)

O-7 UMAN-CM2/3
INSTALLATION OF MEDIA
The following details media installation:
Cameo 2 is illustrated. Loading procedure is identical for
all units.
1. Turn unit off.
2. Squeeze the two finger grips on either side of the
media compartment cover. Rotate the top back to
reveal the paper compartment.
3. If necessary, adjust the edge guide as shown at left
for narrow media.
The edge guide should be set into the nearest slot
in the printer body that will allow the media roll to
spin freely yet prevent it from wandering from side
to side so much that print quality is affected.
4. Drop a new roll of paper into the compartment.
Media should feed from the top of the roll and the
roll should fit between the edge guide and the right
hand wall.
The inner core on the media roll should be Ø.75” [ 19 mm]
or larger to prevent the roll from jamming.
If the unit is a Cameo 2 plus , insure that the media is
fed under the sensor assembly as shown opposite.
If printing on label media, the black bars on the
back of the label media must face up.
5. Close the cover while holding the free end of the
media roll.
6. Insure the cover is securely latched before begin-
ning to print.