Zebra Technologies XiIIIPlus - Manual (Page 26)

O-20 UMAN-CM2/3
Wireless Local Area Network (WLAN)
Printers equipped for Wireless Local Area Network
(WLAN) communications are known as Cameo 3N Net-
work Printers. Cameo 3N printers allow wireless commu-
nication as a node within a local area network, and its
wireless capabilities allow communications from any
point within the LAN’s perimeter. Methods of establishing
communications to the Cameo 3N will vary with each
LAN application.
WARNING: Use of the Cameo 3N will result in expo-
sure to Radio Frequency radiation. To conform to FCC RF
exposure requirements the printer must be used only in
the intended orientation and in the intended manner.
Cameo 3N printers can be identified by a rectangular
pod on the bottom of the printer which contains the radio
module . The printer’s serial number label on the back of
the unit will show the radio module’s identification num-
bers and/or its operating frequency.
The Cameo 3N is designed to be used with a shoulder
strap and a specially designed soft case, or with a belt
clip. The printer should be oriented on the operator’s hip
so that printed material is transported
away from the
operator. Avoid prolonged exposure closer than 5 cm. (2”)
to the radiating area around this unit’s antenna. Refer to
figure below.
When the Cameo 3N is used as designed, either the
printer’s soft case or the belt clip will keep the antenna
the FCC mandated distance away from the operator.