Zebra Technologies XiIIIPlus - Manual (Page 22)

O-16 UMAN-CM2/3
logo on the lower left corner of the keypad.
• By means of a wireless LAN (Local Area Network)
(Cameo 3 Network Printers only) Cameo 3 Net-
work printers are identified by a “Cameo 3N” logo,
and an extension to the bottom cover.
Cable Communications
All Cameo printers can communicate by cable; the
specific cable supplied with your printer will vary with the
host terminal. The 8- pin circular connector on your
communications cable plugs into the serial communica-
tions port on the side of the Cameo printer. (Refer to the
Specifications Section of this manual for communications
port pin assignments.)
The connector is keyed to assure correct alignment; do
not try to force it if it does not plug in. The other end of
the cable must be plugged into the host terminal. Com-
munications between the terminal and the printer is
controlled by the applications running on the terminal and
the printer.