Zebra Technologies XiIIIPlus - Manual (Page 19)

O-13 UMAN-CM2/3
TROUBLESHOOTING
Self Test:
Perform the self test as described in the Controls sec-
tion. The unit should print a line of interlocking “x” char-
acters to insure all elements of the print head are work-
ing, print out the version of software loaded in the printer
and then print two reports. The first report indicates
model, ROM version, serial number, baud rate, etc. The
second report contains application information. If no
second report appears, there is no application loaded.
Cameo 3N units will also print out a “RF LAN Informa-
tion” section with information regarding the printer’s
status on your facility’s’s wireless Local Area Network
(WLAN).
Troubleshooting Guide
No power
• Check battery, recharge or replace as necessary.
Media does not feed:
• Be sure media compartment cover is closed and latched.
Poor or faded print:
• Clean print head.
• Check/replace battery.
• Check quality of media.
Partial/missing print:
• Check media alignment
• Clean print head.
• Verify media compartment cover is closed and latched
Prints illegible characters:
• Check baud rate.
No print:
• Check baud rate
• Replace battery
continued