ZyXEL Communications NSA210 - Manual (Page 35)

Chapter 2 NAS Starter Utility
NSA210 User’s Guide
35
The following screen displays when the hard disk in the NSA has been initilized. It
allows you to configure additional network settings such as host name (server
name) and PPPoE settings.
Figure 9 NAS Starter Utility > Config (Initialized)
The following table describes the labels in this screen. Some fields below do not
apply to the Device List screen when the hard disk in the NSA is uninitialized.
Table 3 NAS Starter Utility > Config
LABEL DESCRIPTION
Server Name The server name is a name that should uniquely identify the NSA in
your network. You can enter up to 15 alphanumeric characters with
minus signs allowed but not as the last character. The name must
begin with an alphabetic character (a-z) and is NOT case sensitive.
Device MAC This is the MAC address of your NSA.
Device IP This is the current IP address of your NSA.
Copy from NSU Click this if you want to manually assign the NSA an IP address that is
in the same subnet as the computer to which your NSA is connected.
When you click this, the IP address of the computer displays. Change
the host ID part of the IP address. If your compter’s IP address is
AAA.BBB.CCC.XXX, change XXX to another number (for example,
from 192.168.1.2 to 192.168.1.3.)
If the computer is connected to the network, use an IP address that is
not yet taken by another computer.
If the computer is not connected to the network, note that the IP
address you assign to the NSA may not work once you connect the
computer or the NSA to the network.
DHCP Select this if the NSA is automatically assigned an IP address from the
ISP or a DHCP server in your network.