3 viewing and editing policy configuration – ZyXEL Communications ES-3124PWR User Manual

Page 158

Advertising
background image

Dimension ES-3124PWR Ethernet Switch

20-4 Policy Rule

Table 20-1 Policy

LABEL DESCRIPTION

Diffserv Select

No change to keep the TOS and/or DSCP fields in the packets.

Select Set the packet’s TOS field to set the TOS field with the value you configure in the TOS
field.

Select Replace the IP TOS with the 802.1 priority value to replace the TOS field with the value
you configure in the Priority field.

Select Set the Diffserv Codepoint field in the frame to set the DSCP field with the value you
configure in the DSCP field.

Outgoing Select

Send the packet to the mirror port to sent the packet to the mirror port.

Select Send the packet to the egress port to send the packet to the egress port.

Select Send the matching frames (broadcast or DLF, multicast, marked for dropping or to be
sent to the CPU) to the egress port
to send the broadcast, multicast, DLF, marked-to-drop or
CPU frames to the egress port.

Select Set the packet’s VLANID to set the VLAN ID of the packet with the value you configure in
the VLANID field.

Metering Select

Enable to activate bandwidth limitation on the traffic flow(s) then set the actions to be taken

on out-of-profile packets.

Out-of-profile
action

Select the action(s) to be performed for out-of-profile traffic.

Select Drop the packet to discard the out-of-profile traffic.

Select Change the DSCP Value to replace the DSCP field with the value specified in the Out of
profile DSCP
field.

Select Do not drop the matching frame previously marked for dropping to queue the frames
that are marked to be dropped.

Add Click

Add to inset the entry to the summary table below.

Cancel

Click Cancel to reset the fields back to your previous configuration.

Clear

Click Clear to set the above fields back to the factory defaults.

20.3 Viewing and Editing Policy Configuration

To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Policy
screen. To change the settings of a rule, click a number in the Index field.

Figure 20-2 Policy: Summary Table

The following table describes the labels in this screen.

Advertising