ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite User Manual
Page 55
Advertising
Omni.Net Lite User’s Guide
Chapter 3 Using AT Commands
54
•
No parity, 8 data bits, 1 stop bit, flow control set to hardware
6 The DTR LED is on. If it is off, check the HyperTerminal settings and your cable
connections.
7 Type in AT and press
[ENTER]
. The terminal will response OK as shown below. You can
now use the commands with an “AT” or “at” prefix to configure the TA. Refer to
for detailed information on AT command sets.
Advertising