ZyXEL Communications ISDN Terminal Adapter Omni.Net Lite - Manual (Page 66)

Omni.Net Lite User’s Guide
65 Chapter 3 Using AT Commands
3.4.8.2 Voice Call
Use AT!pId=<phone number> [/<sub-address>] to configure a list of incoming
call phone numbers (with sub-addresses), then use AT!pP0=n to reject or accept the calls
with the phone number in the list.
3.4.9 Outgoing Call Screening
Use this function to set restrictions on outgoing calls, such as allowing or prohibiting a long-
distance or international call.
Refer to Section 3.4.9 on page 65 for more information.
3.4.9.1 Data Call
Use AT%Od=<prefix digits> to configure a list of prefix digits for outgoing calls, then
use AT%P1=n to prohibit or allow the calls with the prefix digits in the list.
3.4.9.2 Voice Call
Use AT!pOd=<prefix digits> to configure a list of prefix digits for outgoing calls,
then use AT!pP0=n to prohibit or allow the calls with the prefix digits in the list.
Figure 21 AT Command Example 3
3.4.10 Caller ID
Use AT!pA0=n to select the device type to enable call waiting caller ID when you have a call
(see Section 3.4.10 on page 65 for more information).