Zhone Technologies IMACS Network Device User Manual
Page 107
Zhone Technologies, Inc.
IMACS Product Book, Version 4
March 2001
Page 103
BERT Direction
LOOP BACKS
T1/CSU
T1/DSX
E1/CEPT/HDSL
Toward Network
Yes
Yes
Yes
Statistics Gathered By BERT
LOOP BACKS
T1/CSU
T1/DSX
E1/CEPT/HDSL
Bit Errors (BE)
Yes
Yes
Yes
Errored Seconds (ES)
Yes
Yes
Yes
Severely Errored Seconds (SES)
Yes
Yes
Yes
Consecutive Severely Errored Seconds (CSES)
Yes
Yes
Yes
Out of Synchronization Seconds (OSS)
Yes
Yes
Yes
Bit Error Rate (BER)
Yes
Yes
Yes
Elapsed Seconds (ELAP)
Yes
Yes
Yes
HDSL Errored Seconds
N/A
N/A
Yes*
HDSL Severely Errored Seconds
N/A
N/A
Yes*
HDSL Unavailable Seconds
N/A
N/A
Yes*
*
applicable only for the E1-HDSL plug-in module. Also the same statistics are available for the
remote end.
Voice Diagnostics
The software-initiated diagnostics supported on voice cards include the setting of both analog and digital loop backs
toward the network and the generation of Quiet Tone and a Digital MilliWatt signal on a port-by-port basis. The
operator can also monitor and set the state of the analog leads of any FXS, FXO or E&M port. They can set and
monitor the state of the ABCD signaling bits of the digitized voice signal. In cross-connect systems, test
functionality also includes the ability to generate test tones (300Hz, 1 kHz and 3 kHz) and transmit those toward the
user side or the network side of the system. Refer to Table 26 for detailed information on the diagnostic capabilities
of the voice cards.
Table 26—Diagnostic Capabilities of Voice Ports
2-wire
E&M
4-wire
E&M
4-wire
Extended
E&M
2-wire
FXS
2-wire
FXO
LOOP BACKS
On-Card Loop backs
Analog Toward Network
Yes
Yes
Yes
Yes
Yes
Digital Toward Network
Yes
Yes
Yes
Yes
Yes
SIGNALING MANIPULATION
Set Status of Analog Interface Leads
Yes
Yes
Yes
Yes
Yes
Set Transmit ABCD Signaling Bits
Yes
Yes
Yes
Yes
Yes
Set Receive ABCD Signaling Bits
Yes*
Yes*
Yes*
Yes*
Yes*
Monitor Status of Analog Interface Leads
Yes
Yes
Yes
Yes
Yes
Monitor Status of Transmit ABCD Signaling Bits
Yes
Yes
Yes
Yes
Yes
Monitor Status of Receive ABCD Signaling Bits
Yes
Yes
Yes
Yes
Yes
TONE GENERATION
Tones Supported
300 Hz
Yes*
Yes*
Yes*
Yes*
Yes*
1 kHz
Yes*
Yes*
Yes*
Yes*
Yes*
3 kHz
Yes*
Yes*
Yes*
Yes*
Yes*