Zhone Technologies IMACS Network Device - Manual (Page 38)

Zhone Technologies, Inc. IMACS Product Book, Version 4
March 2001 Page 34
the analog Tip and Ring leads of any FXO port. It also sets and monitors the state of the
digitized voice signal’s ABCD signaling bits in cross-connect systems, the Test functionality also
includes the ability to generate test tones (300Hz, 1 kHz, 3 kHz and “quiet”) and transmit those
toward either the user side or the network side of the system.
Table 11 reviews the FXO Card
specifications.
Table 11—FXO Specifications
Model 813960 2-wire Analog FXO
Voice Card
Physical Characteristics
Model 813960 8 ports
Physical Interface 1 female 50-pin Telco connector
Dimensions of Card 8 x 0.94 x 7.48 inches (HWD)
Weight of Card 1 lb or .4 k
Power Consumption of 813960
Card 3.03 W
Models 813960 Signaling Mode Software configurable on a per port basis: Foreign Exchange
Office (FXO), FXO Defined Network, Manual Ringdown and
Dial Pulse Terminating (DPT)
Models 813960 Signaling Type Loop Start, Ground Start, Loop Start Forward Disconnect, Loop
Start R2, Ground Start Automatic, Loop Start E&M, MRD, DPT,
R2, Immediate R2, Dial Pulse E&M, Caller ID
Termination Impedance 600 ohms
VF Transmission Characteristics
Nominal Transmit TLP Software configurable, -10.0dB to +5.0dB, steps of 0.1dB
Nominal Receive TLP Software configurable, -10.0dB to +2.0dB, steps of 0.1dB
2-Wire Return Loss >28 dB Echo, >20 dB singing (against 600 ohm, in series with
2.16 uF with additional 25 ohm resistor between tip and ring
PCM Coding Software configurable, A-Law, A-Law inverted, u-Law
Transhybrid Loss Echo: 22dB, SRL-LO: 14dB, SRL-HI: 20 dB
Standards Conformance
AT&T TR43801
Bell CoreTR-NWT-000057 Digital Channel Bank Requirements and Objectives – November
Functional Criteria for Digital Loop Carrier System – January
1993
BellCore Protections GR-63 CORE
Network Equipment-Building System (NEBS) Requirements:
Physical Protection
ITU-T G.712
ITU-T Q552
ITU-T Q.553 (11/96) – Transmission Performance Characteristics of Pulse Code
Modulation (replaces G.712, G.713, G.714 and G.715)
Transmission Characteristics of 2 –wire analog interface of a Digital
Exchange
Transmission Characteristics of 4 –wire analog
interface of a Digital
Exchange
FCC Part 68 Requirements for Connection of Terminal Equipment Systems and
Protective Apparatus to the Telephone Network
FCC Part 15 Subpart B
UL 1459 Standard for Safety, Telephone Equipment