Xerox 701P21091 - Manual (Page 318)

Specifying print format parameters
4-78 Using LCDS Print Description Language
Options
Default SEMIAUTO
OUTPUT SIZING
parameter: points
to note
• A paper size is considered equal in size to another paper size
if neither dimension differs by more than 15/600 of an inch.
• Use this command to print on paper larger than the specified
paper size. Data may be lost if the paper size is smaller than
the image size.
• Note that A4 paper is treated as smaller than 8.5 by 11 inch
paper because it is narrower.
• Regardless of the parameter selected, if an exact match in
paper size is found, the matching tray is used. The
parameters differ only when no match is found.
Table 4-73. OUTPUT SIZING parameter options and definitions
Option Definition
SEMIAUTO (Standard mode of operation.) Causes the printer to stop printing when
there is a paper size mismatch.
For the printer to resume printing, the operator must do one of the
following:
•
Resume printing to print the job on the next larger size paper.
• Change the paper or the effective stock.
• Cancel the job.
If Continue is selected, the system ignores further mismatches of this type
until one of the following occurs:
•
The STOCKS parameter changes.
• The end of the report is detected, and no STOCKS parameter is in
effect.
• The end of the print job is reached.
• The printer stops printing.
STOP Causes the printer to cycle down if the exact paper size is not available. To
resume operation, the operator must do one of the following:
•
Load the proper size paper and resume printing.
• Cancel the report.
BEST On the DP EPS, this parameter functions the same as SEMIAUTO.
EXACT On the DP EPS, this parameter functions the same as STOP.