Xerox 701P21091 - Manual (Page 405)

Using Dynamic Job Descriptor Entries (DJDEs)
Using LCDS Print Description Language 5-53
LPI DJDE: point to note
If LARGE[ST] was specified for the LINE BASELINE parameter,
the LPI DJDE is ignored.
MAP DJDE
References a font mapping file (FILENAME.LIB) previously
created using a compiled SEFFNT command.
Type Page oriented
Syntax MAP = FILENAME
Options
MARGIN DJDE
Specifies the left printing margin within each logical page. It
takes effect at the logical page following an END DJDE.
Type Page oriented
Syntax MARGIN = value | [value, valuetype]
lineno line number
Specifies the line number or numbers over which the line spacing will be
applied. The options are:
•
n Number of the line to which the specified linespacing will be
applied
• n– Number of the line from which the specified linespacing will be
applied through BOF (bottom of form).
• n–m The specified linespacing will be applied from line n through
line m.
Table 5-42. LPI DJDE options and definitions (Continued)
Option Definition
Table 5-43. MAP DJDE options and definitions
Option Definition
FILENAME Name of the font mapping file to be used.