Xerox 701P21091 - Manual (Page 414)

Using Dynamic Job Descriptor Entries (DJDEs)
5-62 Using LCDS Print Description Language
Options
RFORM DJDE: points to note
• The RFORM parameter is not allowed in a ROUTE command
that is being defined as a catalogued file. However, you may
specify it in the ROUTE command in the JSL invoking the
catalogued RTEXT file, or you can specify it via the RFORM
DJDE. (Refer to the ROUTE RTEXT parameter description in
the “Specifying print format parameters” chapter, for further
details.)
• Forms may be created using forms creation software on a
workstation, or by compiling a file of forms source
commands, called an FSL, with the FDL compiler on another
type of LPS.
• For colored forms: If an inkref that is on the ink list is
omitted from the command, commas must be used to
maintain the relative positioning of the remaining ink
references.
If more than two inkrefs are specified, the system ignores the
additional inkrefs.
RTEXT DJDE
Specifies text to be printed on a separate page preceding a
report. It takes effect on the next page boundary.
The parameters for the RTEXT DJDE are the same as for the
ROUTE RTEXT command.
Type Page oriented
Table 5-51. RFORM DJDE options and definitions
Option Definition
formid form identifier.
Name of the form to be printed with all RTEXT pages. References a previously
created form file (FILENAME.FRM).
NONE Specifies that no form will be printed with RTEXT pages.
INKS Specifies that the inks that follow will be used for the forms.
inkref Identifies the inks that override the corresponding inks that are specified in the
ink list of the form. If a form does not contain an ink list, the form is printed in
black.