Set up the crw2200sx drive, Set up the, P. 12 – Yamaha CRW2200SX User Manual
Page 21: P. 12 – 17), Scsi settings, Scsi id number
Setup Procedures
12
SCSI Settings
Before connecting the CRW2200SX drive to the computer, you need to set up the
following using the dip switches located on the rear of the drive.
➀ SCSI ID Number
➁ Termination
➀
➀
➀
➀
SCSI ID Number
Each of the SCSI devices connected to the computer is identified by its own SCSI ID
number. You need to assign a number from “0” to “7” for each SCSI device.
Commonly, ID number “7” is reserved for the computer’s SCSI card itself.
Therefore, the CRW2200SX drive can actually be assigned an ID number from “0”
to “6.” Set the SCSI ID numbers using the three dip switches as shown below.
Set Up the CRW2200SX Drive
ID SELECT
TERMINATOR
"
Dip switches
Rear panel
SCSI ID 0
SCSI ID 1
(Default)
SCSI ID 2
SCSI ID 3
SCSI ID 7
SCSI ID 6
SCSI ID 5
SCSI ID 4