8e6 Technologies ER3-100 (5K02-55) - Manual (Page 11)

8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide

A. Remove the plastic wrapping from the left and
right U-shaped chassis rail handles.
B. On one side of the chassis (left or right), un-
screw the inner rail from the chassis.
C. Slide the loosened inner rail slightly backwards
to release it from the clips at the side of the
chassis, and then lay it down beside the chas-
sis, with the inside of the rail facing up.
D. On the inner rail that is still attached to the
chassis, insert the bezel pin into the bottom
hole of the U-shaped chassis handle. Be sure
the pin is pushed all the way in so that it is
flush against the handle.
E. Take up the free end of the bezel and also the
loosened inner rail.