8e6 Technologies ER3-100 (5K02-55) - Manual (Page 67)

8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
6 8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
6
a
ppendix
: san i
nstallation
Install the Unit
Link the ER Unit with the SCSI Connected Device
This sub-step is a continuation from the Storage Device Setup (for Attached Storage
Units) portion of Step 1A or 1B in the ER section. The procedures outlined in this step
require the use of the CAT-5E crossover cable and the Ultra SCSI 160 cable.
A. Plug the SCSI cable into the upper right slot on the back of the ER unit (see Figure 1,
Item A).
B. Plug one end of the CAT-5E crossover cable into the ER unit’s LAN 2 port—the port
on the right (see Figure 1 Item B for non-“H” units, and Figure 2 Item B for “H” units).
Figure 1: Back of the non-ER “H” unit
Figure 2: Back of the ER “H” unit
C. Plug the other end of the SCSI cable into the storage device’s upper left disk “0”
(zero) channel (see Figure 3 Item A).
Figure 3: Back of the Nexsan SATABoy