8e6 Technologies ER3-100 (5K02-55) - Manual (Page 13)

8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide

Rack Mount the Server
Rack Setup Precautions
Warning:
Before rack mounting the server, the physical environment should be set up to safely ac-
commodate the server. Be sure that:
The weight of all units in the rack is evenly distributed. Hazardous conditions may be
created by an uneven weight distribution.
The rack will not tip over when the server is mounted, even when the unit is fully
extended from the rack.
For a single rack installation, stabilizers are attached to the rack.
For multiple rack installations, racks are coupled together.
The rack is grounded and will maintain a reliable ground at all times.
A power cord will be long enough to fit into the server when properly mounted in the
rack and will be able to supply power to the unit.
The connection of the server to the power supply will not overload any circuits.
The server is only connected to a properly rated supply circuit. Reliable earthing
(grounding) of rack-mounted equipment should be maintained.
The air flow through the server’s fan or vents is not restricted.
The maximum operating ambient temperature does not exceed 104°F (40°C).
NOTE: Always make sure the rack is stable before extending a component
from the rack.
WARNING: Extend only one component at a time. Extending two or more
components simultaneously may cause the rack to become unstable.
•
•
•
•
•
•
•
•
•
•