3Com iCV-01a User Manual
Page 60
Chapter 5: Using the Utility Program
Once set, Utility will request for the Device Password when you try to click on
either, Setup Wizard, Launch WebCAM or IP Configuration button.
To remove the password,
If the Devise
Password is
enabled, the
IP Address
will be
hidden.
No Devise
Password
set.
a. Select the WebCAM unit from the Utility list.
b. Click
IP Configuration.
c. Enter the unit’s Device Password
d. Go
to
Advanced
Device Password and delete both the entries.
e. Click
OK to confirm.
NOTE:
If the password is lost, you must use the Master Password to reset the Password
field
ii. Management
Protocol
This setting allows the administrator to determine the LAN HTTP access (web)
to WebCAM IP camera. To limit access, the administrator can choose to use
either the default open port 80 or other ports (between 1 to 65534).
Once the HTTP port number is set to another port (other than 80), the full LAN
IP address must be entered in order to access the WebCAM web interface.
WebCAM - user manual
-57-