4XEM IPCAMW45 - Manual (Page 7)

- 3 -
www.4XEM.com
Installation
In this manual, "User" refers to whoever has access to the Network Camera, and
"Administrator" refers to the person who can configure the Network Camera and grant user
access to the camera.
Hardware Installation
Blinking Red
Power is being supplied to the camera.
Steady Green The camera is booting up.
Blinking Orange & Green The camera is trying to obtain an IP address.
Steady Orange An IP address is successfully assigned to the camera.
Blinking Orange & Red The camera is working.
Fast Blinking Orange & Red During firmware upgrading.
Proceed to software installation when the LED status light blinks orange & red.
Status LED Color Description
Using the Power Adapter as power source:
1. Plug the Ethernet cable into the Network Camera.
2. Connect the Power Adapter to the Network Camera.
3. Plug the Power Adapter into electrical outlet.
4. Observe LED status lights (status light progression specified
below).
Using Power over Ethernet PoE as power source:
1. Connect one end of Ethernet cable to 12V PoE injector
(purchased separately).
2. Connect the other end of Ethernet cable to the Network
Camera.
3. Observe LED status lights (status light progression specified
below).
The Power Adapter is not used when powering with PoE.
The Ethernet cable
should meet the specs
of UTP category 5 and
not exceed 100 meters
in length.