2Wire 1000SW - Manual (Page 46)

42
2. The D-Link Air DWL-650 Configuration
screen appears.
3. Select the Configuration tab.
4. In the Mode field, enter Infrastructure .
5. In the SSID field, enter the word “ 2WIRE ”
followed by the last three digits of your
HomePortal serial number. This is the Wireless
Network Name. The Wireless Network Name is
case-sensitive, so it is important that you enter
the word “
2WIRE ” in capital letters.
6. In the Tx Rate pull-down menu, verify that
Fully Automatic is selected (this is the default).
7. In the PS Mode pull-down menu, verify that
Disabled is selected (this is the default).
8. Click Apply Changes .
9. Select the Encryption tab.
10. From the Encryption (WEP) pull-down menu,
select
64 Bit .
11. In the WEP Key Entry field, select the Manual
Entry radio button.
12. In the Key 1 field, enter your ten-digit Wireless
Encryption Key, located on the bottom of your
HomePortal.
13. From the Default Tx Key pull-down, select 1 .
14. Click Apply .
15. Click OK .