3Com 3800 - Manual (Page 60)

4-6 C HAPTER 4: C OMMANDS
Switch 3800
Commands The tables in this section list all of the commands used on the Switch
3800. The commands are organized by the following categories:
■
General Switch commands
■
User account commands
■
Switch management commands
■
VLAN commands
■
Protocol commands
■
FDB commands
■
Port commands
■
PACE commands
■
STP commands
■
Basic IP commands
■
IP Address Resolution Protocol (ARP) commands
■
IP route table commands
■
ICMP commands
■
RIP commands
■
Logging commands
■
Configuration and image commands
unconfig switch {all} Allows you to reset all Switch parameters (with the
exception of defined VLANs and IP addresses) to the
factory defaults. If you specify the keyword “all”, the
IP addresses are reset as well.
Table 4-3 Common Commands (continued)
Command Description
SW3800.BK Page 6 Tuesday, May 5, 1998 5:20 PM