3Com 3800 - Manual (Page 71)

Switch 3800 Commands 4-17
IP ARP Commands Table 4-14 describes IP ARP commands.
disable bootp vlan [<name> | all] Allows you to disable the generation and processing
of BOOTP packets.
enable bootprelay Allows you to enable the BOOTP relay function on
the router.
disable bootprelay Allows you to disable the BOOTP relay function on
the router.
config bootprelay add <ipaddress> Allows you to add IP addresses to be used as IP
destinations to forward BOOTP packets.
config bootprelay delete [<ipaddress> | all] Allows you to delete one or all IP addresses that
were used as IP destinations to forward BOOTP
packets.
Table 4-13 Basic IP Commands (continued)
Command Description
Table 4-14 IP ARP Commands
Command Description
show iparp {<ipaddress> | vlan <name> |
all | permanent}
Displays the current Address Resolution Protocol
(ARP) cache for a selected IP address, VLAN, or all
entries. With no options, information for all
VLANs is displayed.
Information displayed includes IP address, MAC
address, aging timer value, VLAN name, VLANid,
and port number.
clear iparp [<ipaddress> | vlan <name> |
all]
Allows you to remove dynamic entries in the IP
ARP table.
config iparp add <ipaddress> <mac_address> Allows you to add a permanent IP ARP entry to
the system. The IP address is used to match the
IP interface address to locate a suitable interface.
config iparp delete <ipaddress> Allows you to delete an IP ARP entry from the
table.
SW3800.BK Page 17 Tuesday, May 5, 1998 5:20 PM